Total Weed Control – Pistol
- Long lasting – prevents germination for 6 months
- Resilient – controls many difficult weeds
- Rainfast in 1 hour
- Classified Non-hazard/Non-irritant to the operator
- Dual action formulation
To control annual and perennial broad-leaved weeds and grasses apply 225ml of PISTOL® in a minimum of 10L of water over 500m2.
This is equivalent to 4.5l/ha in a minimum of 200 litres of water per hectare.
45 ml Pistol in 2-4 L of water treats 100m2
A knapsack fitted with a flat fan nozzle or similar, using a pressure of around 1-2 bar is recommended. Good and even coverage of foliage and soil is essential for optimum activity.
PISTOL® is classified as Non-hazard and Non-irritant to the operator under Chip 3 and COSHH regulations. PISTOL® is a water based non-solvent formulation.
PISTOL’S® special liquid formulation is very ‘rainfast’. Once the spray application has dried, usually within 1 hour of application, rainfall will not interfere with its ability to control weeds.
Dual action formulation
PISTOL® combines the systemic activity of glyphosate with the soil acting residual properties of diflufenican. The two different active ingredients are specially formulated to provide the ultimate long lasting total weed control.
Bayer Tip: For established deep rooted perennial weeds such as dandelion, thistle, dock and nettles which may be re-generating, a post-emergence application is ideally required.
Safe Use of Pesticides
The purchaser and/or end users are responsibile for ensuring that these products are used in line with industry Approved Codes of Practice. All operators must be trained and certificated in using and applying any professional product.
IMPORTANT: ALWAYS READ READ AND FOLLOW ATTACHED PDF LABEL AND SAFETY INSTRUCTIONS BEFORE BUYING OR USING THIS PRODUCT. FOR PROFESSIONAL USE ONLY
Please be aware that by proceeding you are purchasing a professional pesticide product. You must ensure the end user of these products complies with the DEFRA/HSE Code for the Safe use of Pesticides:
“By law, everyone who uses pesticides professionally must have received adequate training in using pesticides safely and be skilled in the job they are carrying out.”
Approved for use on hard surfaces.
Controls grasses, broad leaved weeds and mosses. New-Way Weedspray produces discolouration and browning of the foliage within a few hours of treatment. Perennial weeds generally require more than one application for control but annual weeds are usually controlled with one treatment.
Application Apply the spray so that leaves and stems are fully wetted before run-off. As the product works by contact action it is important that the weed is fully covered otherwise there will be partial control. The product is not translocated within the plant and therefore is safer to use around trees, shrubs and other valuable plants.
Mixing Mix 1 part New-Way Weedspray to 3 parts of clean water. For example in a 16 litre knapsack sprayer mix 4 litres of New-Way Weedspray to 12 litres of water in the following manner. Half fill spray tank with clean water. Add the required amount of New-Way Weedspray. Fill the tank with more clean water to the required level. Agitate before use.
Can be used all year round.
Rates variable. 5L pack
FOR PROFESSIONAL USE ONLY
3 – 7.5 L / ha. 5L pack
FOR PROFESSIONAL USE ONLY
Sustainable Use of Pesticides Directive (SUD)·
After 26th November 2015, it is illegal to apply Professional Use PPPs (Plant Protection Products) unless you are registered as a PU (Professional User) with the DAFM (Department of Agriculture, Food & the Marine) and have been allocated a PU No. · In the event of a DAFM inspection, you will be required to produce evidence of having completed appropriate training. You can apply for registration as a PU at any time provided you have been suitably trained – see http://www.pcs.agriculture.gov.ie/sud/sudreg/